Step 5:Configuring Basic Settings For The Camera - JAI GO-5000M-USB-UV User Manual

Step 5: Changing the Camera Settings
This section explains how to change settings by describing the procedure for changing the
output format as an example.
Configuring the Output Format
Configure the size, position, and pixel format of the images to be acquired.
The factory settings are as follows. Change the settings as necessary.
Factory default values
ImageFormatControl
* You can specify the image acquisition area. For details, see "ROI (Regional Scanning Function)".
1
Configuring the [Width] of［ImageFormatControl］
By selecting the item of [Width], you can change the value as shown below.
Device Control
Visibility
DeviceControl
DeviceVendorName
DeviceModelName
DeviceManufactureInfo
DeviceVersion
DeviceFirmwareVersion
DeviceSerialNumber
DeviceUserID
DeviceTemperature
DeviceReset
ImageFormatControl
WidthMax
HeightMax
Width
Height
Offset X
Offset Y
BinningHorizontal
BinningVertical
PixelFormat
TestImageSelector
Acquisition Control
AcquisitionMode
AcquisitionStart
AcquisitionStop
Note
Depending on the setting item, you need to change visibility.
Please switch visibility (Beginner / Expert / Guru) as necessary.
Item
Width
Height
OffsetX (horizontal position)
OffsetY (vertical position)
PixelFormat
Beginner
JAI Corporation
GO-5000M-USB-UV
See the possibilities
XXXXX
XXXXX
XXXXX
JAI_DEMO
XXXXX
ー
2560
2048
2560
2048
0
0
1
1
Mono8
Off
Continuous
×
×
— 15 —
GO-5000M-USB-UV
Default value
2560
2048
0
0
Mono8