Front Brake Pads - Ranger; Pad Removal / Disassembly; Brake Pad Inspection - Polaris RANGER ETX 2015 Owner's Manual

BRAKE SYSTEM

FRONT BRAKE PADS - RANGER

PAD REMOVAL / DISASSEMBLY

1. Elevate and support front of machine.
CAUTION
Use care when supporting vehicle so that it does not tip
or fall. Severe injury may occur if machine tips or falls.
2. Remove the front wheel. Loosen pad adjuster screw
q
2-3 turns.
3. Remove the two caliper bolts
mounting bracket.
4. Push caliper piston into caliper bore slowly using a
C-clamp or locking pliers with pads installed.
Brake fluid will be forced through compensating port
into master cylinder fluid reservoir when piston is
pushed back into caliper. Remove excess fluid from
reservoir as required.
9.12
w
and caliper from
NOTE
9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual
5. Push upper pad retainer pin
brake pad past edge. Remove the pad.

BRAKE PAD INSPECTION

1. Check the brake pads for wear, damage, or
looseness.
2. Inspect the brake pad wear surface for excessive
wear.
MEASUREMENT
Brake Pad
.030" (0.762 mm)
3. If any one pad is less than the service limit then all
pads should be replaced.
e
inward and slip outer
© Copyright Polaris Industries Inc.