Reassembly, Front Gearcase (Adc) - Polaris RANGER ETX 2015 Owner's Manual

19. Inspect the input shaft bushing
20. Thoroughly clean the gearcase components before
beginning reassembly.
9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual
© Copyright Polaris Industries Inc.

REASSEMBLY, FRONT GEARCASE (ADC)

1. Clean the gearcase housing of debris.
2. Replace all O-rings, seals, and worn components.
3. Inspect bearings on output and pinion shafts. To
Due to extremely close tolerances and minimal wear,
the bearings must be inspected visually, and by feel.
spots, discoloration, or corrosion. The bearings should
turn smoothly and quietly, with no detectable up and
down movement and minimal movement side to side.
j
for wear.
4. Install input shaft, bearing, and snap ring.
5. Press the pinion shaft seal into the gearcase, until the
6. Install the LH output hub
replace, press new bearing onto shaft.
NOTE
While rotating bearings by hand, inspect for rough
seal is flush.
housing. The output hub should spin freely.
FINAL DRIVE
7
s
into the gearcase
7.27