Parking Brake Caliper Installation - Polaris RANGER ETX 2015 Owner's Manual

Table of Contents

5. Disassemble and add shims between plate washer

and the rear brake pad as needed to close the gap to

0.193"-0.203" (4.902 - 5.156 mm).

6. Install rear pad, spacers (if removed), springs, front

pad, and then loosely install the nuts.

7. Slide mounting bolt sleeves through the pads to

maintain alignment of parts.

8. Torque the assembly nuts to specification.

Parking Brake Caliper - Assembly Bolts:

35 ft-lb (47 Nm)

9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual

9. Ensure the assembly functions properly by actuating

the lever before reinstallation. It should move freely

and return to the upright position when released.

PARKING BRAKE CALIPER INSTALLATION

1. Install parking brake assembly on the mounting

bracket. Tighten two mounting bolts evenly to

specification.

2. Torque two bracket mounting bolts (if bracket was

removed) to specification.

Caliper-to-Bracket Bolts:

19 ft-lb (26 Nm)

Caliper Bracket-to-Transaxle Case Bolts:

19 ft-lb (26 Nm)

3. Install the cable to lever arm with pin (pin is installed

from front to rear).

4. Install retainer clip in pin.

BRAKE SYSTEM

Table of Contents