Balance Shaft Installation / Timing - Polaris RANGER ETX 2015 Owner's Manual

11. Torque the cam chain retainer plate
specification.
TORQUE
Cam Chain Retainer Screw:
7 ft-lbs (10 Nm)
12. Turn the assembled crankcase over and support the
connecting rod in an upright position.
13. Install new crankcase studs into crankcase using a
commercially available stud installation tool.
NOTE
Stud Thread Pitch: M8 x 1.25
TORQUE
Cylinder Head Studs:
13 ft-lbs (17 Nm) (Replacement required)
14. Proceed with installing the top-end of the engine.
9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual
© Copyright Polaris Industries Inc.
q

BALANCE SHAFT INSTALLATION / TIMING

screw to
1. Position balancer shaft
2. Install balance shaft bearing retainer
fasteners
Balance Shaft Retainer Fasteners:
3. Align keyway and install balancer shaft gear on the
balancer shaft.
4. Rotate crankshaft to align the timing marks
shown below.
ENGINE / COOLING SYSTEM
q
in the crankcase.
w
e
to specification.
TORQUE
7 ft-lbs (10 Nm)
3
and torque
y
as
3.81