Front Brake Pads; Seat; Pad Removal / Disassembly; Brake Pad Inspection - Polaris RANGER 500 2018 Service Manual

Hide thumbs Also See for RANGER 500 2018:

Table of Contents

FRONT BRAKE PADS

1. Elevate and support front of machine.

Use care when supporting vehicle so that it does not tip

or fall. Severe injury may occur if machine tips or falls.

2. Remove the front wheel. Loosen pad adjuster screw

3. Remove the two caliper bolts

mounting bracket.

4. Push caliper piston into caliper bore slowly using a

C-clamp or locking pliers with pads installed.

Brake fluid will be forced through compensating port

into master cylinder fluid reservoir when piston is

pushed back into caliper. Remove excess fluid from

reservoir as required.

9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual

5. Push upper pad retainer pin

brake pad past edge. Remove the pad.

1. Check the brake pads for wear, damage, or

2. Inspect the brake pad wear surface for excessive

and caliper from

3. If any one pad is less than the service limit then all

pads should be replaced.

BRAKE SYSTEM

inward and slip outer

.030" (0.762 mm)

Table of Contents