Clutch Assembly - Polaris RANGER ETX 2015 Owner's Manual

Table of Contents

32. Working from inside of cover, insert new bushing and

bushing installation tool into center of clutch cover.

33. With main adapter on puller, insert cover onto puller

rod, placing outside of cover toward vise.

34. Install nut on rod and hand tighten. Turn puller barrel

to apply more tension if needed.

35. Turn clutch cover counterclockwise on puller rod until

bushing is seated.

36. Remove nut from puller rod. Take installation tool

and clutch cover off rod.

9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual

CLUTCH ASSEMBLY

The Teflon bushings are self-lubricating.

Do not apply oil or grease to the bushings.

Reassemble the drive clutch in the following sequence.

Be sure the "X", or the marks that were made earlier are

aligned during each phase of assembly.

1. Install the PTFE washers

over the clutch shaft. There should be one fiber

washer on each side of the bearing.

2. Install the moveable sheave and spacer

clutch shaft.

To maintain proper clutch balance and belt-to-sheave

clearance. be sure to reinstall the original quantity and

thickness of washers / spacers beneath the spider

during assembly.

and non braking bearing

Table of Contents