Uncorrected System Performance Test - Agilent Technologies ENA Series Service Manual

Performance Tests
Individual Test Description
N(m) 50  - N(f) 75  adapter (for opt. 175/275)

7. Uncorrected System Performance Test

Description
This test checks the directivity, source match, load match, transmission tracking, and
reflection tracking which are the key S-parameter measurement hardware characteristics.
These characteristics are tested using the Agilent 85032B or 85036B Calibration Kit at 300
kHz to 1.5 GHz (up to 3 GHz for the E5062A). After an enhanced response calibration
performed for each test port, the test software is executed to output the directivity, source
match transmission tracking, and reflection tracking data. The load match for a responce
port is measured by a stimulus (source) port performed a 1-port calibration.
Test Equipment
Calibration Kit (for opt. 150/250)
Coaxial cable with Type-N (m) connector, 50 , 61 cm
(24 in) (for opt. 150/250)
Calibration Kit (for opt. 175/275)
Coaxial cable with Type-N (m) connector, 75 , 61 cm
(24 in) (for opt. 175/275)
36
Agilent p/n 1250-0597
Agilent 85032B
Agilent N6314A (p/n
8120-8862)
Agilent 85036B
Agilent p/n 8120-8898
Chapter 2