Agilent Technologies ENA Series Service Manual page 103

Test Items The following test can be selected. To execute the test you select, click
"Execute" button.
• A1 Board DC-BUS Test
• A2 Board DC-BUS Test
• A1 Board Internal Level Monitor Test
• A2 Board Internal Level Monitor Test
• Source Power Accuracy (Step Attenuator) Test
• Source Power Linearity (Power sweep) Test
• Receiver Absolute Gain Test
• Receiver Compression Test
• Receiver IF Range Test
• Handler I/O Test
When each test is executed, the test dialog box is displayed. The
following screen is an example of the test dialog box.
Figure 4-12 Test dialog box
To execute the test, click "Execute" button. To return the
E5061A/E5062A Diagnostic test program dialog box (Main Menu),
click "Back to Main Menu".
The test program will prompt you to connect cables or Short
termination to the E5061A/E5062A. Follow the instructions as shown
below on the E5061A/E5062A display for performing the test.
Chapter 4
Troubleshooting
Troubleshooting Using Diagnostic Test
103