To Check The Device Driver - Agilent Technologies ENA Series Service Manual

Table 4-4 Major functions and troubleshooting procedures
Function
LAN port
Printer parallel port
GPIB Interface
Handler I/O port

To Check the Device Driver

Make sure first whether the E5061A/E5062A device drivers are installed properly or not
by the following procedure, if a function of specific device in the E5061A/E5062A doesn't
work.
Step 1. Exit from the E5061A/E5062A measurement view in accordance with the procedure
described in "How to exit from the E5061A/E5062A Measurement View" on page 89.
Then, Windows desktop screen is displayed.
Step 2. Click "My Computer" with the right button and select "Properties" as shown in Figure
4-14. Then, the System Properties(Figure 4-15) will appear.
Figure 4-14 Opening System Property Window
Chapter 4
Description
The LAN interface port on the rear panel allows
the E5061A/E5062A to be connected to 10/100
Base-T Ethernet.
A specified printer can be used to print the
E5061A/E5062A measurement display, setup
display and others, when it is connected to the
Printer port (36-pin D-Sub) on the rear panel.
The GPIB compatibility allows the
E5061A/E5062A to be operated as a talker/listener
on IEEE 488 interface bus.
The Handler I/O port can be used to transfer a
comparator decision output data to and perform
timing synchronization with an external handler.
Troubleshooting
Function Specific Troubleshooting
Troubleshooting
Refer to "To Check the
LAN" on page 112.
Refer to "To Check the
Printer Parallel Port" on
page 116.
Refer to "To Check the
GPIB" on page 116.
Refer to in "To Execute the
Diagnostic Test" on
page 101 .
107