Agilent Technologies ENA Series Service Manual page 28

Performance Tests
Instruction for Using the Performance Test Software
Figure 2-2 USB to GPIB Configuration dialog box
If you need to check/change the setting of the USB/GPIB interface after connecting the
USB/GPIB interface, follow these steps:
Step 1. Press
Step 2. Press
Step 3. Press
Step 4. Press
Step 5. The IO Config dialog box (Figure 2-3) appears. Select (highlight)
Figure 2-3) and then click the
NOTE In the IO Config dialog box, do not click buttons other than specified here or do not change
other settings because doing so may cause serious damage to the functions of the
E5061A/E5062A.
28
.
Misc Setup .
.
GPIB Setup
System Controller Configuration
Edit
.
button (2 in Figure 2-3).
(1 in
GPIB0 hpib7
Chapter 2