Fan Replacement; Tools Required; Removal Procedure; Replacement Procedure - Agilent Technologies ENA Series Service Manual

Replacement Procedure

Fan Replacement

Fan Replacement

Tools Required

•
•
•

Removal Procedure

Refer to Figure 6-11 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 166.
Step 2. Remove the front panel as described in "Front Panel Removal" on page 167.
Step 3. Disconnect the fan cable (item 1) from the A21 PCI DSP Card.
Step 4. Remove the four rivets (plastic) fastening the fan.
Figure 6-11 Fan Removal
Replacement Procedure
Step 1. Reverse the order of the removal procedure.
182
TORX screwdriver, T15 and T20
Flat edge screwdriver
A fine stick such as Hex key, 1.5 mm
Chapter 6