Agilent Technologies ENA Series Service Manual page 126

Troubleshooting
To configure the A20 Digital Motherboard and BIOS
Change Supervisor Password
A password needs to be entered to execute the BIOS setup utility. If a password has not
been assigned in the E5061A/E5062A, set the password using this BIOS setup utility as
follows.
a. Select "Security" using
key.
b. Select "Set Supervisor password" using
c. Enter the password of "e506xa". Never set another password.
d. Press key.
e. If a message of "New supervisor password installed. Press any key to continue" is
displayed, press
Save & Exit Setup
When you want to change and save a BIOS option, Select "Exit" using
BIOS Setup Utility main menu and press
and press key. Then select "Exit Saving Changes" using
key. A message of "SAVE to CMOS and EXIT (Y/N)?" is displayed. Press
keys.
The BIOS setup utility is closed after the current settings are saved.
Exit Without Saving
If you cancel the changes in the BIOS option settings, select "Exit Discarding Change"
using keys at the Exit Menu and press
Without Saving (Y/N)?" is displayed. Press
The BIOS setup utility is closed without saving the current settings.
126
keys at the BIOS Setup Utility main menu and press
keys and press
key.
key. Select "Save CMOS to Flash" using
and
key.
keys at the
key. Then, a message of "Quit
keys.
Chapter 4
and press
and