Mount An Ex4100 And Ex4100-F Switch On Four Posts In A Rack Or Cabinet - Juniper EX4100 Hardware Manual

6. Ensure that the switch chassis is level by verifying that all screws on one side of the rack are aligned
with the screws on the other side.
Figure 70: EX4100 and EX4100-F Chassis Installed in Rack
Mount an EX4100 and EX4100-F Switch on Four Posts in a Rack or
Cabinet
Before mounting the switch on four posts in a rack:
• Verify that the site meets the requirements described in
Requirements" on page
• Place the rack in its permanent location, allowing adequate clearance for airflow and maintenance,
and secure it to the building structure.
General Safety Guidelines and Warnings
• Read
Lifting Guidelines .
Ensure that you have the following parts and tools available:
• Phillips (+) screwdriver, number 2
• 6 flat-head 4-40 mounting screws (provided with the four-post rack-mounting kit)
• 12 flat-head 4x6-mm Phillips mounting screws (provided with the four-post rack-mounting kit)
• One pair each of flush or 2-in.-recessed front-mounting brackets (provided with the four-post rack-
mounting kit)
87.
, with particular attention to
"EX4100 and EX4100-F Site Guidelines and
Chassis and Component
126