Juniper EX4100 Hardware Manual page 16

2 10/100/1000BASE-T RJ-45 non-PoE
—
network ports
3 Chassis status LEDs (labeled SYS, ALM, MST,
—
and CLD)
Port mode LEDs (labeled SPD, DX, and EN)
4
—
5 Factory Reset/Mode button
—
Figure 9 on page 7 shows the components on the front panel of the EX4100-48P switch.
Figure 9: Components on the Front Panel of the EX4100-48P Switch
1 Front mounting brackets
—
2 10/100/1000BASE-T RJ-45 network ports.
—
These ports in EX4100-48P switches support
PoE+ (30 W by default).
3 Chassis status LEDs (labeled SYS, ALM, MST,
—
and CLD)
4 Port mode LEDs (labeled SPD, DX, EN, and
—
PoE)
Factory Reset/Mode button
5
—
7 1GE/10GE SFP+ Uplink ports
—
8 10GE/25GE SFP28 Virtual Chassis ports
—
Reset button
9
—
10 Claim Code label
—
6 RS232 to USB Type-C console port
—
7 1GE/10GE SFP+ Uplink ports
—
8 10GE/25GE SFP28 Virtual Chassis ports
—
9 Reset button
—
7