Juniper EX4100 Hardware Manual page 182

11. Configure the default gateway.
[edit]
root# set routing-options static route 0/0
12. Configure the IP address and prefix length for the management interface on the switch.
[edit]
root# set interfaces vme unit 0 family inet address
NOTE: The management port vme (labeled MGMT) is located on the rear panel of the switch.
13. (Optional) Configure the IP address of a backup router, which is used only while the routing
protocol is not running.
[edit]
root# set system backup-router
14. Configure the IP address of a DNS server.
[edit]
root# set system name-server
15. (Optional) Configure the static routes to remote subnets with access to the management port.
Access to the management port is limited to the local subnet.
[edit]
root# set routing-options static route
readvertise
16. (Optional) Configure the static routes to remote prefixes with access to the management port.
[edit]
root# set routing-options static route
readvertise
next-hop address
address
address
remote-subnet next-hop destination-IP retain no-
remote-prefix next-hop destination-IP retain no-
address/prefix-length
173