Juniper EX4100 Hardware Manual page 136

• One pair of side-mounting rails (provided with the four-post rack-mounting kit)
• One pair of rear-mounting blades (provided with the four-post rack-mounting kit)
• Screws to secure the chassis and the rear-mounting blades to the rack (not provided)
You can mount an EX4100 and EX4100-F switch on four posts of a 19-in. rack or cabinet by using the
separately orderable four-post rack-mounting kit. (The remainder of this topic uses
cabinet .)
NOTE: If you need to mount the switch in a recessed position on either a two-post rack or a
four-post rack, you can use the 2-in.-recessed front-mounting brackets provided in the
separately orderable four-post rack-mounting kit.
NOTE: One person must be available to lift the switch while another secures the switch to the
rack.
CAUTION: If you are mounting multiple units on a rack, mount the heaviest unit at the
bottom of the rack and mount the other units from the bottom of the rack to the top in
decreasing order of the weight of the units.
To mount the switch on four posts in a rack:
1. Remove the switch from the shipping carton (see
page 119).
2. Place the switch on a flat, stable surface.
"Unpack the EX4100 and EX4100-F Switch" on
rack to mean rack or
127