Connect The Ex4100 And Ex4100-F Switch To The Network; Install A Transceiver - Juniper EX4100 Hardware Manual

Connect the EX4100 and EX4100-F Switch to the
Network
IN THIS SECTION

Install a Transceiver | 149

Connect a Fiber-Optic Cable | 152
Install a Transceiver
Before you install a transceiver in a device, ensure that you have taken the necessary precautions for
safe handling of lasers (see
Ensure that you have a rubber safety cap available to cover the transceiver.
The transceivers for Juniper Networks devices are hot-removable and hot-insertable field-replaceable
units (FRUs). You can remove and replace them without powering off the device or disrupting the device
functions.
NOTE: After you insert a transceiver or after you change the media-type configuration, wait for
6 seconds for the interface to display operational commands.
NOTE: We recommend that you use only optical transceivers and optical connectors purchased
from Juniper Networks with your Juniper Networks device.
CAUTION: The Juniper Networks Technical Assistance Center (JTAC) provides
complete support for Juniper-supplied optical modules and cables. However, JTAC does
not provide support for third-party optical modules and cables that are not qualified or
supplied by Juniper Networks. If you face a problem running a Juniper device that uses
Laser and LED Safety Guidelines and Warnings ).
149