Juniper EX4100 Hardware Manual page 144

c. Drill a hole (C) at a distance of 18.67 in. (47.43 cm) on a plumb line down from screw A and install
a mounting screw.
d. Drill a hole (D) at a distance of 18.67 in. (47.43 cm) on a plumb line down from screw B and install
a mounting screw.
Figure 82: Measurements for Installing Mounting Screws
4. Place the switch against the wall such that the front panel of the switch faces to the right side and
the holes in the mounting bracket heads align with the mounting screw heads.
5. Slide the switch chassis to the left or right a bit so that the mounting screws are pushed into the
channels of the holes in the mounting brackets until the switch rests firmly in place as shown in
Figure 83 on page 136.
135