Juniper EX4100 Hardware Manual page 183

17. Configure the SSH service.
[edit]
root# set system services ssh root-login allow
18. Configure in-band management or out-of-band management:
• With in-band management, you can configure a network port interface as the management
interface and connect it to the management device. In this scenario, you can do either of the
following:
• Use the automatically created VLAN named
members of the default VLAN. Specify the management IP address and the default gateway.
• Create a new management VLAN. Specify the VLAN name, VLAN ID, management IP
address, and default gateway. Select the ports that must be part of this VLAN.
• With out-of-band management, you use a dedicated management channel (MGMT, C0, or C1
port) to connect to the management device. Specify the IP address and gateway of the
management interface. Use this IP address to connect to the switch.
19. (Optional) Specify the SNMP read community, location, and contact to configure SNMP parameters.
20. (Optional) Specify the system date and time. Select the time zone from the list. The configured
parameters are displayed.
21. Enter yes to commit the configuration. The configuration is committed as the active configuration
for the switch.
22. (Optional) Configure additional properties by adding the necessary configuration statements.
23. Commit the configuration to activate it on the switch.
[edit]
root# commit
24. When you have finished configuring the switch, exit configuration mode.
[edit]
root@switch# exit
root@switch>
You can now log in by using the CLI and continue configuring the switch.
default for management of all data interfaces as
174