Configure Junos Os On An Ex4100 And Ex4100-F Switch - Juniper EX4100 Hardware Manual

3. Insert the cable connector into the optical transceiver (see
Figure 98: Connect a Fiber-Optic Cable to an Optical Transceiver Installed in a Device
4. Secure the cables so that they do not support their own weight. Place excess cable out of the way in
a neatly coiled loop. Placing fasteners on a loop helps cables maintain their shape.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend radius. An arc
smaller than a few inches in diameter can damage the cables and cause problems that
are difficult to diagnose.
Do not let fiber-optic cables hang free from the connector. Do not allow fastened
loops of cables to dangle, which stresses the cables at the fastening point.
Configure Junos OS on an EX4100 and EX4100-F
Switch
IN THIS SECTION
EX4100 and EX4100-F Default Configuration | 154
Connect and Configure an EX4100 and EX4100-F Switch | 170
Revert to the Default Factory Configuration on an EX Series Switch | 175
Figure 98 on page
Fiber-optic Transceiver
cable
153).
153