Mount An Ex4100 And Ex4100-F Switch On A Wall - Juniper EX4100 Hardware Manual

12. Secure the rear-mounting brackets to the rear post of the rack by using four screws appropriate for
your rack.
Figure 79: Secure the Switch to the Rear Post of the Rack by Using the Rear-Mounting Brackets
13. Look around the installed switch to ensure that the switch is installed correctly.
Figure 80: Chassis Fully Installed in Rack
14. If required, cover the SFP ports with the dust covers.

Mount an EX4100 and EX4100-F Switch on a Wall

Before mounting a switch on a wall:
• Verify that the site meets the requirements described in
EX4100-F Switches" on page
• Read General Safety Guidelines and Warnings
Lifting Guidelines
.
Ensure that you have the following parts and tools available:
85.
, with particular attention to
"Site Preparation Checklist for EX4100 and
Chassis and Component
133