Maintain Transceivers; Remove A Transceiver - Juniper EX4100 Hardware Manual

10. If you are not replacing the power supply, install the cover panel over the slot.
Figure 104: Remove a DC Power Supply from an EX4100 Switch

Maintain Transceivers

IN THIS SECTION

Remove a Transceiver | 190

Install a Transceiver | 193
Remove a Transceiver
Before you remove a transceiver from a device, ensure that you have taken the necessary precautions
for the safe handling of lasers (see
Ensure that you have the following parts and tools available:
• An antistatic bag or an antistatic mat
• Rubber safety caps to cover the transceiver and fiber-optic cable connector
• A dust cover to cover the port or a replacement transceiver
Laser and LED Safety Guidelines and Warnings
).
190