Juniper EX4100 Hardware Manual page 140

General Safety Guidelines and Warnings
• Read
Lifting Guidelines
.
Ensure that you have the following parts and tools available:
• Number 2 Phillips (+) screwdriver (not provided)
• Eight screws to secure the mounting brackets to the rack (not provided)
• An ESD grounding strap (not provided)
• Recessed-mounting brackets to mount the switch in a recessed position from the front posts of a
rack—2 (provided with the four-post rack-mounting kit)
• Flat head 4-40 Phillips screws to attach the recessed-mounting brackets to the side rails of the
bracket assembly—6 (provided with the four-post rack-mounting kit)
• Flat head 4x6-mm Phillips screws to attach the front-mounting bracket assembly to the chassis—12
(provided with the four-post rack-mounting kit)
To mount an EX4100 and EX4100-F switch in a recessed position from the front posts of a 19-in. four-
post rack:
1. Remove the switch from the shipping carton (see
page 119).
2. Place the switch on a flat, stable surface.
3. Wrap and fasten one end of the ESD wrist strap around your bare wrist, and connect the other end
of the strap to a site ESD point.
4. Attach the recessed-mounting brackets provided with the four-post rack-mounting kit to the side
rails by using the flat head 4-40 Phillips screws provided with the four-post rack-mounting kit .
Figure 76: Attach the Recessed-Mounting Bracket to the Side Rail
5. Align the recessed-mounting bracket assembly along the side panel of the switch.
, with particular attention to
"Unpack the EX4100 and EX4100-F Switch" on
Chassis and Component
131