Registering Products-Mandatory For Validating Slas; Mounting An Ex4650 Switch On Four Posts Of A Rack Or Cabinet - Juniper EX4650 Series Hardware Manual

NOTE: You must provide the appropriate mounting screws for mounting the switch on a rack.
Registering Products—Mandatory for Validating SLAs
Register all new Juniper Networks hardware products and changes to an existing installed product using
the Juniper Networks website to activate your hardware replacement service-level agreements (SLAs).
CAUTION:
the installation base data if there is any addition or change to the installation base or if
the installation base is moved. Juniper Networks will not be held accountable for not
meeting the hardware replacement service-level agreement for products that do not
have registered serial numbers or accurate installation base data.
Register your product(s) at https://tools.juniper.net/svcreg/SRegSerialNum.jsp.
Update your installation base at
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp.

Mounting an EX4650 Switch on Four Posts of a Rack or Cabinet

You can mount an EX4650 switch on four posts of a 19-in. rack or a 19-in. cabinet by using the separately
orderable four-post rack-mount kit. (The remainder of this topic uses rack to mean rack or cabinet.)
NOTE:
To ensure that the protective earthing terminal is accessible through the opening in the rear
mounting-blade:
Ensure that the rack is 27.5 in. (70 cm) through 30.5 in. (77.5 cm) deep if you are mounting the
switch flush with the rack front on four posts of a rack.
Ensure that the rack is 29.5 in. (75 cm) through 32.5 in. (82.5 cm) deep if you are mounting the
switch 2 in. recessed from the rack front.
Before mounting the switch on four posts of a rack:
Register product serial numbers on the Juniper Networks website and update
83