Rear Half Shaft Installation - Polaris RZR PRO R Service Manual

FINAL DRIVE
4. Remove the radius rod outer mounting bolts
and washers from the bearing carrier. Swing radius
rods down.
5. With a sharp, short jerk, remove drive shaft from the
rear gearcase.
8.10

REAR HALF SHAFT INSTALLATION

w
, nuts
1. Apply anti-seize to inboard splines and install half
shaft into rear gearcase.
2. Install drive shaft through the backside of the bearing
carrier.
3. Install upper and lower radius rods. Torque fasteners
to specification.
Inner Radius Rod Fasteners (Single Use): 52 ft-lbs
(70 Nm) + 90°Outer Radius Rod Fasteners: 133 ft-
4. Install NEW wheel axle nut. Torque nut to
specification.
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
TORQUE
Rear Radius Rod Fasteners:
lbs (180 Nm) - Torque bolt side
TORQUE
Wheel Axle Nut:
89 ft-lbs (120 Nm)
© Copyright Polaris Industries Inc.