Eps Unit / Steering Rack Replacement - Polaris RZR PRO R Service Manual

INSTALLATION
1. Reverse removal procedure for installation.
TORQUE
Tilt Bracket Mounting Fasteners:
33 ft-lbs (45 Nm)
Front Coil Assembly Fasteners:
27 in-lbs (3 Nm
Coil Assembly Side Fastener:
27 in-lbs (3 Nm
Steering Wheel Nut:
66 ft-lbs (90 Nm)
Steering Shaft Bearing Fasteners:
22 ft-lbs (30 Nm)
Steering Shaft Pinch Bolt:
22 ft-lbs (30 Nm)
EPS UNIT / STEERING RACK
REPLACEMENT
REMOVAL
1. Remove upper and lower steering shaft. Refer to
lower steering shaft removal outlined in this chapter.
2. Remove four front fascia fasteners
front fascia.
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
3. Remove four fasteners
bumper.
4. Both sides of vehicle: Remove ball joint pinch bolt
washer, and nut from the upper control arms.
q
and remove
5. Driver's side only: Remove two control arm mounting
fasteners
The access panel must be removed from the driver's
side footwell to remove rear upper control arm fastener.
STEERING / SUSPENSION
i
and remove the front
e
.
IMPORTANT
w
,
9
9.7