Transmission / Gear Position Switch; Brake Pressure Switch - Polaris RZR PRO R Service Manual

TRANSMISSION / GEAR POSITION
SWITCH
The transmission (gear position) switch
the rear of the transmission and can be accessed
through the rear LH wheel well area.
TESTING
1. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the connector. Do
not pull on the wiring.
2. Test the transmission switch continuity readings for
each gear position and compare to the specification
table below.
RESISTANCE VALUE
GEAR
WHEN MEASURED AT SWITCH
POSITION
TERMINALS A AND B
HIGH
LOW
NEU
REV
PARK
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.

BRAKE PRESSURE SWITCH

The brake pressure switch
line outlet on the master cylinder.
q
is located on
1. Disconnect the wire harness from the brake switch.
2. Connect an ohmmeter across switch contacts.
3. Apply foot brake and check for continuity between
620 Ω
300 Ω
160 Ω
75 Ω
24 Ω
q
is located on the rear brake
TORQUE
Brake Pressure Switch:
15 ft-lbs (20 Nm)
NOTICE
Always replace brake system seals if fastener is
loosened or removed.
Reading should be infinite (OL).
switch contacts. If there is no continuity or greater
than 0.5 Ω resistance when the brake is applied with
slight pressure, first clean the switch contacts and re-
test. Replace switch if necessary.
ELECTRICAL
12
12.15