Polaris RZR PRO R Service Manual page 355

4. Properly support the suspension using a floor jack or
tie down strap to prevent suspension from fully
drooping.
CAUTION
Suspension must be supported when the shock
absorber is removed. If suspension is not properly
supported, suspension weight will rest on the inner tie
rod, which may result in damage to the tie rod and/or tie
rod boot.
Suspension/knuckle should be supported using a floor
jack, or securely strapped to a vehicle tie-down point on
the chassis.
5. Remove lower shock fastener
w
bar link fastener .
6. Remove and discard ball joint nut
control arm mounting fasteners
7. Remove lower control arm.
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
INSTALLATION
1. Loosely install lower control arm, mounting fasteners,
q
and lower stabilizer
2. Install lower shock and stabilizer bar link fasteners
e
. Remove two
r
.
3. Torque Fasteners to specification.
STEERING / SUSPENSION
and NEW ball joint nut into place.
into the control arm.
TORQUE
Control Arm Mounting Fasteners:
133 ft-lbs (180 Nm) - Torque bolt side
TORQUE
Lower Ball Joint Fastener:
44 ft-lbs (60 Nm) + 90° (Single Use)
TORQUE
Shock Mounting Fastener:
133 ft-lbs (180 Nm) - Torque bolt side
TORQUE
Stabilizer Bar Link Fastener:
81 ft-lbs (110 Nm)
9
9.17