Belt Installation - Polaris RZR PRO R Service Manual

BELT INSTALLATION

1. With the clutch spreader tool installed, loop the belt
over the drive clutch and over part of the driven
clutch. Be sure to install belt in the direction
previously marked.
2. Rotate the driven clutch and walk the belt into the
clutch.
3. Remove the clutch spreader tool from the driven
clutch.
4. Rotate / spin the driven clutch and belt approximately
5-7 times to properly seat the belt in the driven clutch.
5. Install outer clutch cover. Install five fasteners
engage 1/4 turn latches to secure the cover. Torque
fasteners to specification.
TORQUE
Outer PVT Cover Fasteners:
60 in-lbs (7 Nm)
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
6. Install clutch intake hose. Tighten hose clamp
Torque hose clamp to specification.
e
and
PVT Intake Hose Clamp:
7. Install upper and lower rear close-off panels.
8. Install seats. On 4-seat models, install the rear seats.
PVT SYSTEM
w
TORQUE
35 in-lbs (3 Nm)
.
6
6.5