Polaris RZR PRO R Service Manual page 293

a
22. Install two O-rings onto the transmission.
23. Install inner clutch cover and inner clutch cover
i o
fasteners and . Torque fasteners to specification.
TORQUE
Inner PVT Cover Fasteners:
q q w w
: 11 ft-lbs (15 Nm)
24. Install drive clutch stationary sheave.
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
: 35 in-lbs (4 Nm)
25. Install drive clutch moveable sheave and drive clutch
u
. Torque fastener to specification.
retaining bolt
TORQUE
Drive Clutch Retaining Bolt:
Step 1: 140 ft-lbs (190 Nm)Step 2: Loosen two full
turns (720°)Step 3: 118 ft-lbs (160 Nm)
NOTICE
When drive clutch is fully installed, the spring coupler
between the engine and drive clutch may allow up to
approximately 30 degrees of free rotation when turning
clutch by hand. This rotation range is normal.
r
26. Install driven clutch, bolt
y
. Torque fastener to specification.
TORQUE
Driven Clutch Retaining Bolt:
55 ft-lbs (75 Nm)
27. Install the drive belt.
TRANSMISSION
t
, spacer , and washer
7.15
7