MacDon R113 Unloading And Assembly Instructions page 12

Rotary disc 13-foot self-propelled windrower header

Hide thumbs Also See for R113:

Table of Contents

9. Remove the wire (A) that is holding skid shoe (B).

10. Tilt skid shoe (B) inward, and align link (A) with

mounting hole in skid shoe.

11. Install bolt (C), washer, and nut.

12. Push the skid shoe towards the header, and tighten nut.

13. Repeat previous four steps for opposite side.

214075

ASSEMBLING THE HEADER

Figure 2.7: Skid Shoe Supported (Left Side

Shown)

Figure 2.8: Skid Shoe (Left Side Shown)

Revision A

Table of Contents