MacDon R113 Unloading And Assembly Instructions page 34

Rotary disc 13-foot self-propelled windrower header

Hide thumbs Also See for R113:

Table of Contents

13. Remove clevis pin from storage position (B) in linkage

and insert into hole (A) to engage float springs. Secure

with hairpin.

14. Disengage safety prop by turning lever (A) downwards

to release and lower stop until lever locks into

vertical position.

15. Repeat for opposite safety prop.

CAUTION

Check to be sure all bystanders have cleared the area.

16. Start the engine and activate the HEADER DOWN

switch (A) on the GSL to fully lower the header.

17. Stop engine and remove key from ignition.

214075

ATTACHING HEADER TO WINDROWER

Figure 3.40: Header Float Linkage

Figure 3.41: Safety Prop

Figure 3.42: Ground Speed Lever

Revision A

Table of Contents