Removing Shipping Stands - MacDon R113 Unloading And Assembly Instructions

2.3 Removing Shipping Stands

NOTE:
This procedure must be completed on both sides of the header.
1. Remove bolts (A).
2. Remove bolt (B).
3. Cut any shipping wire from the legs of the header.
4. Remove hair pin (A) from clevis pin (B).
5. Hold shipping stand (C) and remove clevis pin (B).
6. Remove stand (C) and discard. Reinsert pin (B) in
header lifting arm and secure with hair pin (A).
7. Remove hooks (A) at front corners and
reinstall hardware.
NOTE:
If tall crop divider option will be installed, do not reinstall
hardware.
214075
ASSEMBLING THE HEADER
Figure 2.11: Shipping Stands (Right Side Shown
– Left Side Opposite)
Figure 2.12: Shipping Stands (Right Side
Shown – Left Side Opposite)
Figure 2.13: Shipping Hook
9
Revision A