MacDon R113 Unloading And Assembly Instructions page 79

7. Position forks (B) under frame as shown ensuring
packing foam (or equivalent) is between forks and
frame. Raise forks to lift frame slightly. Ensure forks do
not contact frame.
8. To secure frame to forks, wrap chain (C) around end of
forks and attach to forklift.
9. Pick up frame and position it against header as shown.
10. Slowly move forward until the lift arm (C) is lined up with
the mounting holes in the frame (A) and (B).
11. Install only bolt (A) through the frame (B) and
bushing (D) in the lift arm. Repeat for opposite side.
12. Check the gap (C) between the inner steel sleeve (D) of
the bushing and the frame (B). If there is a gap,
washers (1.2 mm thick) (MD #5113) will need to be
installed to minimize the gap on both sides of the
bushing.
13. Remove bolt (A).
214075
CHANGING THE CONDITIONER
Figure 8.12: Installing Frame
Figure 8.13: Frame (Left Side Shown)
Figure 8.14: Frame Attachment
(Left Side Shown)
73
Revision A