10. Disconnect steel line (A) from elbow (B) and tee (C)
(inside frame) and remove line. Discard line.
11. Install cap (A) on tee.
12. Reposition elbow (B) as shown.
13. Remove two existing nuts (A) securing multicoupler to
bracket (B).
14. Position new bracket (C) onto existing bolts and secure
with existing nuts (A).
15. Install rubber coupler holder (D) into bracket (C).
214075
ATTACHING HEADER TO WINDROWER
32
Figure 3.49: Tractor Couplers
Figure 3.50: Tractor Header Drive
Figure 3.51: Tractor Couplers
Revision A