MacDon R113 Unloading And Assembly Instructions page 31

Rotary disc 13-foot self-propelled windrower header

Hide thumbs Also See for R113:

Table of Contents

3. Relocate pin (A) in frame linkage as required to raise

the center-link (B) until the hook is above the

attachment pin on the header.

IMPORTANT:

If the center-link is too low, it may contact the header as the

windrower approaches the header for hookup.

4. Drive the windrower slowly forward until the windrower

feet (A) enter the header supports (B). Continue driving

slowly forward until the feet engage the supports and

the header nudges forward.

5. Use the following GSL functions to position the center-

link hook above the header attachment pin:

• HEADER TILT UP (A) to retract the center-link

• HEADER TILT DOWN (B) to extend the center-link

6. Stop engine and remove key from ignition.

214075

ATTACHING HEADER TO WINDROWER

Figure 3.33: Hydraulic Center-Link

Figure 3.34: Header Support

Figure 3.35: Ground Speed Lever

Revision A

Table of Contents