Installing Conditioner Drive - MacDon R113 Unloading And Assembly Instructions

8.2.1 Installing Conditioner Drive

This procedure describes the installation of conditioner drive components on a machine that was originally supplied
with no conditioner.
Retrieve bag from conditioner shipment containing the following parts:
• Shaft key
• Pulley
• Bushing with three M10 bolts
• Tensioner assembly
• M16 hex head bolt
1. Remove two screws (A) from cover (B), and remove
cover from gearbox shaft. Retain parts for future use.
2. Assemble pulley (A) and bushing (B) onto gearbox shaft
with key (C).
3. Install three M10 hex head bolts (D) through
bushing (B) into pulley (A).
214075
CHANGING THE CONDITIONER
• M16 nut
• Two M10 nuts
• Eye bolt
• Hardened washer
• Spring
Figure 8.18: Shaft Cover
Figure 8.19: Drive Pulley
75
Revision A