Checking Roll Timing; Adjusting Roll Timing - MacDon R113 Unloading And Assembly Instructions

7.3 Checking Roll Timing

Check roll timing if excessive noise is coming from the conditioner rolls.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
Roll timing is factory-set and should not require adjustment. However, if there is excessive noise coming from the
conditioner rolls, the timing will need to be adjusted. Refer to

7.3.1 Adjusting Roll Timing

1. Loosen four bolts (A) in slots of yoke plate (B) on upper
roll universal shaft.
NOTE:
Only three of the four bolts are shown in the illustration.
214075
PERFORMING PREDELIVERY CHECKS
52
7.3.1 Adjusting Roll Timing, page
Figure 7.4: Conditioner Drive
52.
Revision A