MacDon R113 Unloading And Assembly Instructions page 26

IMPORTANT:
If the center-link is too low, it may contact the header as the windrower approaches the header for hookup.
3. Activate the REEL UP switch (A) on the GSL to raise
the center-link until the hook is above the attachment
pin on the header.
4. Drive the windrower slowly forward until the windrower
feet (A) enter the header supports (B). Continue driving
slowly forward until the feet engage the supports and
the header nudges forward.
5. Use the following GSL functions to position the center-
link hook above the header attachment pin:
• REEL UP (A) to raise the center-link
• REEL DOWN (B) to lower the center-link
• HEADER TILT UP (C) to retract the center-link
• HEADER TILT DOWN (D) to extend the center-link
214075
ATTACHING HEADER TO WINDROWER
20
Figure 3.20: Ground Speed Lever
Figure 3.21: Header Support
Figure 3.22: Ground Speed Lever
Revision A