MacDon R113 Unloading And Assembly Instructions page 23

16. Install clevis pin (A) through support and foot and
secure with hairpin (B). Repeat for opposite side.
IMPORTANT:
Ensure clevis pin (A) is fully inserted, and hairpin is installed
behind bracket.
17. Disengage safety prop by turning lever (A) downward to
raise safety prop until lever locks into vertical position.
NOTE:
If safety prop will not disengage, raise header slightly.
18. Repeat for opposite side.
CAUTION
Check to be sure all bystanders have cleared the area.
19. Start engine and press HEADER DOWN switch (A) on
GSL to fully lower header.
214075
ATTACHING HEADER TO WINDROWER
17
Figure 3.12: Header Support
Figure 3.13: Cylinder Safety Prop
Figure 3.14: Ground Speed Lever
Revision A