Conditioner Drive Belt; Removing Conditioner Drive Belt - MacDon R113 Unloading And Assembly Instructions

8.3 Conditioner Drive Belt

The conditioner drive belt is located inside the left driveshield and is tensioned with a spring tensioner. The tension
is factory-set and should not require adjustment.

8.3.1 Removing Conditioner Drive Belt

DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Lower header fully, turn off engine, and remove key.
2. Remove the left driveshield. Refer to
Driveshields, page 83.
3. Disconnect wire harness (A) from speed sensor (B).
4. Turn jam nut (A) counterclockwise to unlock
tension adjustment.
5. Turn jam nut (A) and adjuster nut (B) counterclockwise
to fully collapse tensioner spring (C), and release the
tension from conditioner drive belt (D).
6. Remove drive belt (D).
214075
CHANGING THE CONDITIONER
9.1 Opening
Figure 8.23: Speed Sensor
Figure 8.24: Conditioner Drive
77
Revision A