Chapter 7: Performing Predelivery Checks; Checking Conditioner Drive Belt; Adjusting Conditioner Drive Belt - MacDon R113 Unloading And Assembly Instructions

7 Performing Predelivery Checks
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
1. Perform final checks and adjustments as listed on the yellow sheet attached to back of this instruction, to
ensure the machine is field-ready. Refer to the referenced pages as indicated on the checklist for detailed
instructions.
2. The completed checklist should be retained either by the Operator or the Dealer.

7.1 Checking Conditioner Drive Belt

1. Open the left driveshield. For instructions, refer to
2. Check that the belt (A) is properly located on the pulleys
and tensioned. Overall spring length (B) should be 365
mm (14-3/8 in.). If adjustment is required, refer to
Adjusting Conditioner Drive Belt, page
3. Check that the adjuster nuts (C) are tight.
4. Close driveshield. For instructions, refer to
Driveshields, page 85.

7.1.1 Adjusting Conditioner Drive Belt

DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Shut down the engine and remove the key from ignition.
2. Open the left driveshield. Refer to
214075
9.1 Opening Driveshields, page
7.1.1
49.
9.2 Closing
9.1 Opening Driveshields, page
49
83.
Figure 7.1: Conditioner Belt
83.
Revision A