MacDon R113 Unloading And Assembly Instructions page 64

Rotary disc 13-foot self-propelled windrower header

Hide thumbs Also See for R113:

Table of Contents

6. Remove oil level inspection plug (A) and O-ring (B) from

cutterbar.

7. Oil level must be up to the bore. If required, add

lubricant as follows:

a. Replace inspection plug.

b. Start windrower engine, and raise header slightly.

c. Lower header onto blocks so that left end is slightly

higher than right end.

NOTE:

Refer to the inside back cover of this manual for

lubricant specifications.

IMPORTANT:

Do NOT overfill the cutterbar. Overfilling can cause

overheating and damage to, or failure of, cutterbar

components.

d. Remove breather (A) at left end, and add sufficient

lubricant to required level.

e. Replace breather and recheck oil level.

214075

PERFORMING PREDELIVERY CHECKS

Figure 7.13: Cutterbar

Figure 7.14: Adding Lubricant

Revision A

Table of Contents