YASKAWA DX100 Maintenance Manual page 626

Alarm Alarm Name Sub
Number Code
38
39
40
41
42
43
44
Meaning Cause
Kinematic friction coefficient data Software operation
error error occurred
The setting in the optimized Software operation
acceleration/deceleration error occurred
designation parameter is incorrect.
An uninstalled function is Software operation
designated. error occurred
The dynamics-model calculation at Software operation
the optimized acceleration/ error occurred
deceleration is invalid.
Zero is set for the inertia of Software operation
dynamics fixed model. error occurred
Designation error for dynamics- Software operation
model calculation type error occurred
The optimized acceleration/ Software operation
deceleration control of speed limit error occurred
function is disabled.
Remedy
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your Yaskawa representative about occurrence status
(operating procedure).