YASKAWA DX100 Maintenance Manual page 514

Alarm Alarm Name Sub
Number Code
6
7
8
Meaning Cause
YCP01 board failure (1)Turn the power OFF then back ON.
An error occurred in the acquisition Setting error
process of domain during the
network service data creation
process of the Ethernet function.
YCP01 board failure (1)Turn the power OFF then back ON.
An error occurred in the acquisition Setting error
process of SNTP server during the
network service data creation
process of the Ethernet function.
YCP01 board failure (1)Turn the power OFF then back ON.
An error occurred in the acquisition Setting error
process of host name during the
network service data creation
process of the Ethernet function.
Remedy
(2)If the alarm occurs again, replace the YCP01 board. Save the CMOS.BIN
before replace the board to be safe. Replace the YCP01 board, and then
insert the CF card which inserted original YCP01 board into the new YCP01
board.
(1)Check the following settings.
·The DHCP server operation (If the DHCP is used)
·The network status (If the DHCP is used)
(2)If the alarm occurs again, replace the YCP01 board. Save the CMOS.BIN
before replace the board to be safe. Replace the YCP01 board, and then
insert the CF card which inserted original YCP01 board into the new YCP01
board.
(1)Check the following settings.
·The DHCP server operation (If the DHCP is used)
·The network status (If the DHCP is used)
(2)If the alarm occurs again, replace the YCP01 board. Save the CMOS.BIN
before replace the board to be safe. Replace the YCP01 board, and then
insert the CF card which inserted original YCP01 board into the new YCP01
board.
(1)Check the following settings.
·The DHCP server operation (If the DHCP is used)
·The network status (If the DHCP is used)