YASKAWA DX100 Maintenance Manual page 191

Hide thumbs Also See for DX100:

The station No. specified by the

Setting error

DeviceNet allocation file2 is

incorrect (the station No. is out of

the allowable range, or the

specified station board is not the

DeviceNet master).

YCP01 board failure (1)Turn the power OFF then back ON.

YIF board failure

The MAC_ID specified by the

Setting error

DeviceNet allocation file2 is not

consistent with the MAC_ID of the

specified station board.

YCP01 board failure (1)Turn the power OFF then back ON.

(1)Check the following settings.

[XFB01 board]

· The settings of the objective DeviceNet allocation file

· The I/O module settings of the objective DeviceNet board in maintenance

· The DeviceNet allocation of the I/O module in maintenance mode

(2)If the alarm occurs again, replace the YCP01 board. Save the CMOS.BIN

before replace the board to be safe. Replace the YCP01 board, and then

remove the CF from the failure YCP01 board to insert it into the new YCP01

(1)Turn the power OFF then back ON.

(2)If the alarm occurs again, replace the YIF01 board. Save the CMOS.BIN

before replace the board to be safe. Replace the YIF01 board, and then load

the CMOS.BIN saved before alarm occurred.