Populating Patient Data Over The Network - Dräger Infinity M300 Series Instructions For Use Manual

8 Enter the patient's birth date in the Date of birth field (E) – Day, Month, Year.
9 Enter the admit date in the Admit date fields (F) – Day, Month, Year.
10 Enter the weight of the patient in the Weight field (G). For M300 patients, the supported weight range
is: 0.1 kg to 350 kg (1 lb to 772 lb).
11 Enter the height of the patient in the Height field (H). For M300 patients, the supported height range
is: 20 cm to 240 cm (8 in to 100 in).
NOTE
For M300 patients, the system setup setting determines the units of measure (see "General settings set-
up page" on page 207).
12 Select the gender of the patient in the Gender field (I) – Unknown, Male, Female.
13 Select the pacemaker type in the Type of implant fields (J). This selection appears when the corre-
sponding function is configured at the ICS. The possible selections are: None, Pacer, ICD, PCD, EXT.
14 Select the telemetry ID from the drop-down list of available devices in the Telemetry device ID field
(K). The list is pre-populated during the setup of the M300.
15 Scroll through the list and select the ID corresponding to the M300 device you want to admit.
16 Select the Apply button to save your changes, or Undo to remove any changes made since the last
time the Apply button was selected.
If you changed any existing demographic data, the updated data are now sent to the M300.

Populating patient data over the network

You can populate the Demographics page automatically, by retrieving the demographic data of a patient
from the network. Prerequisite for this network data transfer is the Infinity Gateway with an interface to the
ADT (Admit, Discharge, Transfer) Hospital Information System (HIS). Based on the patient ID, the HIS
searches the database for the demographic data of the patient. After modifying demographic data at the
bedside, the updated information in the database will not display until the patient is re-admitted at the ICS.
If patient demographic information is changed or updated from a location other than the CentralStation,
you must re-select the Apply button from the Admit/Standby page to update the stored information in the
database.
To populate patient data via Get data
In the following steps, the letters in parentheses refer to the diagram of the Demographics page. For
information about the Demographics page, refer to the Instructions for use Infinity CentralStation Wide,
Software VG4.0 or later.
1 Select a viewport that either has an M300 label or has a bedside admitted.
2 Select the Admit/Standby button from the BedView menu bar to display the Admit/Standby dialog
window.
3 Select the Demographics tab if not already selected.
Instructions for use – Infinity ® M300 and M300+ series – VG3.0
Getting started
109