Electromagnetic Compatibility (Emc) - Dräger Infinity M300 Series Instructions For Use Manual

Technical specifications
Infinity M300 Radio emissions statement
NOTE
This device was developed and produced in a manner that the emission limits for RF (Radio
Frequency Energy), defined by the FCC (Federal Communication Commission), by RSS (Radio Stan-
dards Specification) and by ETSI, IEC 60601-1-2, will not be exceeded. These limits are part of interna-
tional safety standards and defined by international committees.
NOTE
The Infinity M300 and M300+ complies with part 15 of the FCC rules. Operation is subject to the following
two conditions:
– This device may not cause harmful interference.
– This device must accept any interference received, including interference that may cause undesired
operation.

Electromagnetic compatibility (EMC)

Medical electrical equipment is subject to special precautionary measures concerning electromagnetic
compatibility. During installation and before initial operation, follow the information in section: "EMC
declaration for M300/M300+"(page 291).
This device can be affected by other electrical devices.
WARNING
Risk due to electrostatic discharge
Malfunctions that endanger the patient may occur if no protective measures against electrostatic
discharge are employed in the following situations:
– When touching the pins of connectors that carry the ESD warning symbol.
– When establishing connections with these connectors.
To prevent malfunctions, observe the following measures and train the relevant personnel:
– Observe the ESD protective measures. Such measures may include wearing antistatic cloth-
ing and shoes, touching a potential equalization pin before and while making the connection,
or using electrically insulating and antistatic gloves.
– Observe the requirements for the electromagnetic environment. Observe the following sec-
tion: "Electromagnetic environment"(page 291).
290 Instructions for use – Infinity ® M300 and M300+ series – VG3.0