Configuring Alarm Settings For Multiple; Parameters - Dräger Infinity M300 Series Instructions For Use Manual

Alarms
A Parameter labels column
B Alarm (on/off) column
C Lower limits column
D Actual (current) parameter values column
E Upper limits column
F Archive column
G Restore button in the Limits defaults field– restores system default settings; only available for the
M300
H Apply button
I Undo button
J Auto set button in the Limits field
Configuring alarm settings for multiple parameters
In the following steps, the letters in parentheses refer to the diagram of the Alarms > Limits page
(see "Alarm setup for multiple parameters" on page 127). For alarm ranges and defaults for the M300,
see "M300 alarm ranges and defaults" on page 134.
WARNING
Setting alarm limits to extreme values may prevent certain alarm conditions from being detected
and from being annunciated with audio and visual alarm signals.
To configure the alarm settings of a bedside monitor or M300
1 Select the Alarms button in the menu bar of the BedView page.
2 Select the Limits tab (if not already selected).
3 Select the corresponding button in the Alarm on/off column (B) to enable or disable alarm monitoring.
A crossed-out triangle
4 Select the corresponding button in the Lower column (C) to adjust the lower alarm limits.
5 Select the corresponding button in the Upper column (E) to adjust the upper alarm limits.
6 Use one of the following settings in the Archive column (F) to determine what happens in response to
an alarm:
– Off – no event is stored and no recording is generated.
– Store – stores the event in the disclosure database.
NOTE
An event will not be saved unless the specific alarm is turned on AND the alarm is generated.
128
symbol appears in the parameter box when alarm monitoring is disabled.
Instructions for use – Infinity ® M300 and M300+ series – VG3.0